27 Arc Flash Label Requirements

Interestingly the earlier draft of the article 11016 for 2017 nec listed additional items to be included on the label such as the arc flash boundary incident energy levels and level of ppe required. Whenever an arc flash study is done or revised and new arc flash warning labels must be considered it is a good idea to define exactly what information belongs on each label before starting to print anything.

Understanding Arc Flash Hazards 2018 02 05 Achrnews

Preferreddetailed arc flash label example osha arc flash violation samples.

arc flash label requirements. The arc flash boundary refers to the distance. This material was produced under grant number sh 16615 07 60 f 12 from the occupational safety and health administration us. In the event of an electrical accident the absence of field labeled electrical equipment is cause for an osha violation and you assume a liability risk by ignoring the arc flash hazard labeling requirement in 1303c of nfpa 70e 2009.

Arc flash label requirements basic arc flash label requirements. The electrician or maintenance person in the field. Labeling is required for any piece of electrical equipment that may need examination adjustment service or maintenance while energized creating the potential for an arc flash incident to occur.

Arc flash labeling is the responsibility of the employer not the manufacturer or installer of the equipment. Arc flash label format. At minimum the safety program needs to be audited at intervals not to exceed three years and arc flash risk assessment shall be periodically reviewed at intervals not to exceed five years.

Ultimately rather than explicitly state these requirements in 11016bs bullet points. Once the evaluation is complete an arc flash hazard warning label must be affixed to the equipment and readily accessible to employees who may work on the energized equipment. An approach limit located at the distance.

Label format should conform to the ansi z5354 products safety signs. Arc flash label best practices when deciding what information to include on your company labels always remember for whom the labels are posted. June 28 2019 hudapack metal treating of illinois inc based in glendale heights il has been cited by osha for failure to use electrical safety work practices provide appropriate personal protective equipment train employees and repair damaged electrical outlets.

Any modifications or renovations to electrical equipment that will change data on the label will require an updated arc flash risk assessment and label according to the 2015 nfpa 70e standard.

Nfpa 70e 2018 Changes Arc Flash Requirements Brady